2x3 Building Brick Soap Pump Cover
2x3 Building Brick Soap Pump Cover
Soap Dispenser Cover
Couldn't load pickup availability
Turn Your Soap Bottle Into a Giant Building Brick
Give an everyday soap bottle an upgrade with our 2x3 Building Brick Soap Pump Cover.
Designed to look like an oversized classic building brick, the cover fits around a compatible hand soap bottle while leaving the original pump exposed and ready to use.
It's a simple way to add some personality to your kitchen, bathroom or laundry without needing to transfer your soap into a separate dispenser.
Compatible Soap Bottles
Our 2x3 Building Brick Soap Pump Cover has been designed and tested to fit the following hand soap bottles:
- Palmolive 250ml Hand Wash
- Silk 300ml Hand Wash
- Dettol 250ml Hand Wash
The same cover fits all three bottle types, so you can choose your preferred soap and simply replace the bottle when it's empty.
Other bottles may also fit, but we can only guarantee compatibility with the bottles we have tested.
Easy to Use
Fitting the cover only takes a few moments. Unscrew the pump from your compatible soap bottle, place the bottle inside the cover, then feed the neck of the bottle through the opening at the top. Refit the pump and tighten it back onto the bottle to hold everything in place.
When the soap runs out, simply unscrew the pump, remove the empty bottle and replace it with another compatible bottle. The cover can be reused again and again.
Made in New Zealand
Each cover is 3D printed by Upscale Prints in New Zealand.
The oversized 2x3 brick design makes a fun addition to a bathroom, kitchen, laundry, kids' bathroom, building brick collection or themed space.
It also makes a great gift for building brick fans who already seem to have everything.
What's Included
One 3D printed 2x3 Building Brick Soap Pump Cover.
Soap bottle and pump are not included.
Please check the compatible bottle information before ordering. Due to differences in bottle shapes and sizes, we cannot guarantee fitment with bottles that are not listed as compatible.
Due to the nature of 3D printing, minor layer lines and surface variations may be visible. These are a normal characteristic of the process and are not considered defects.
Artist: Upscale Prints
Materials
Materials
This soap pump cover is 3D printed in PETG, a durable material that is well suited to use in areas where it may be exposed to occasional splashes and moisture.
While PETG is suitable for a wet environment, the cover is not designed to be submerged in water or exposed to hot water.
To clean, simply wipe the cover with a damp cloth and allow it to dry. Do not soak, place in a dishwasher, or clean with hot water.
Dimensions
Dimensions
Some products contain small parts and are not suitable for children under 5 years due to choking hazards.
Our items are 3D printed using durable plastics but may break if dropped, bent or used with excessive force. If a product becomes damaged or broken discontinue use immediately.
These products are not intended as children's products unless specifically stated.
